Xylem HandyLab 600 - Manual (Page 44)

Settings HandyLab 600
44 ba77064e01 03/2014
You can change the interval (1 ... 999 days):
7.2 ORP measurement settings
7.2.1 Settings for ORP measurements
The settings are made in the menu for measuring settings of the ORP measure-
ment. To open the settings, display the required measured parameter in the
measured value display and press the <ENTER> key. After completing the set-
tings, switch to the measured value display with <M>.
Default settings are printed in bold.
7.3 Sensor-independent settings
7.3.1 System
To open the Storage & config menu, press the <ENTER_> key in the measured
value display. After completing the settings, switch to the measured value dis-
play with <M>.
Default settings are printed in bold.
1. Open the menu for measurement settings with <ENTER>.
2. In the Calibration / Calibration interval menu, set the calibration interval
with <><>.
3. Confirm the setting with <ENTER>.
4. Quit the menu with <M>.
Menu item Possible setting Explanation
mV resolution 0.1
1 Resolution of the mV display
Reset - Resets all sensor settings to the
delivery condition (see section
7.4.1 R
ESETTING THE MEASUREMENT
SETTINGS , page 47).
Menu item Possible setting Explanation
System / General / Lan-
guage Deutsch
English
(more) Selects the menu language
System / General / Audio
signal on
off Switches on/off the beep on keystroke
System / General / Illumi-
nation Auto
on
off Switches the display illumination on/off