YSI DIQ/S 182 XT-4 System 182 XT-4 - Manual (Page 25)

System 182 XT-4 Installation
3 - 11 ba76026e01 01/2012
Caution
For optimum stability only one MIQ module may be attached to
the DIQ/S 182 XT-4.
Note
In all MIQ modules in the System 182 XT-4, the terminator switch on
the terminal strip must be set to "Off".
Materials required  2 x ISO blind nuts (M4)
 2 x cheese-head screws (M4x16) with plastic washer
 1 x contact base with two plastic tapping screws (scope of delivery
of the MIQ module).
Tools  Phillips screwdriver.
Both installation variants of the attachment of an MIQ module on the
DIQ/S 182 XT-4 is described in the following. The assembly of further
MIQ modules is carried out analogously. To dismantle a stack, proceed
in the reverse order to mounting.