YSI DIQ/S 182 XT-4 System 182 XT-4 - Manual (Page 56)

Installation System 182 XT-4
3 - 42 ba76026e01 01/2012
Fig. 3-30 24 V AC/DC connection.
Note
The complete assignment of the terminal strip is shown in section 3.14.
Warning
No free wires must be allowed to project into the enclosure.
Otherwise there is the danger of short circuits that can cause a
fire. Always cut off any wires that are not in use as closely as
possible to the cable gland.
8 Connect wires 1 and 2 to the terminal strip. Make sure that the
cable assignment agrees with the specification on the terminal
label under the terminal strip.
9 Tighten the coupling ring (pos. 3 in Fig. 3-29).
10 Close the enclosure of the DIQ/S 182 XT-4.
Terminal
designation:
X17 X16
24V AC DC
INPUT
POWER