YSI DIQ/S 182 XT-4 System 182 XT-4 - Manual (Page 95)

System 182 XT-4 Outputs
6 - 3 ba76026e01 01/2012
6.2 Linking and adjusting: general procedures
6.2.1 linking outputs
Linking options The following options of linking outputs are available:
 Sensor Sxx
The output is linked with sensor 0x
 Sensor S01&S02
The output is linked to both sensors S01 and S02.
This option is available for relay outputs only.
 System
Select this option if you want to use the output for system monitoring
(details, see section 6.4.2).
Procedure:
linking outputs
Proceed as follows if the output was not yet linked. If you want to
change a link, you have to erase the existing link first.
1 Open the SETTINGS menu with
s
.
2 Select the menu item Relay output Rx or mA output Cy with
w
and
g
and confirm. A list with all linking options is
displayed.
3 Select the required option with
w
and confirm with
g
.
The output is linked. The link is displayed in the header when
the setting of the output is edited.