YSI MultiLab 4010P-1 - Manual (Page 26)

Operation MultiLab 4010-1
26 ba76141e03 03/2014
4.5.5 Example 2 on navigation: Setting the date and time
The meter has a clock with a date function. The date and time are indicated in
the status line of the measured value display.
When storing measured values and calibrating, the current date and time are
automatically stored as well.
The correct setting of the date and time and date format is important for the fol-
lowing functions and displays:

Current date and time
 Calibration date
 Identification of stored measured values.
Therefore, check the time at regular intervals.
Setting the date,
time and date format
The date format can be switched from the display of day, month, year
(dd.mm.yy) to the display of month, day, year (mm/dd/yy or mm.dd.yy).
After a fall of the supply voltage (empty batteries), the date and time
are reset.
1. In the measured value display:
Using <MENU/ENTER__>, open the Storage & config menu.
The instrument is in the setting mode.
2. Select and confirm the System / Clock function menu with <><>
and <MENU/ENTER>.
The setting menu for the date and time opens up.
3. Select and confirm the Time menu with <><> and <MENU/ENTER>.
The hours are highlighted.
4. Change and confirm the setting with <><> and <MENU/ENTER>.
The minutes are highlighted.
5. Change and confirm the setting with <><> and <MENU/ENTER>.
The seconds are highlighted.
Date format: dd.mm.yy
Date: 03.04.2013
Time: 14:53:40
Clock function
03.04.2013
08:00
Back