YSI MultiLab 4010P-1 - Manual (Page 72)

Settings MultiLab 4010-1
72 ba76141e03 03/2014
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the <MENU/
ENTER> key.
9.6.2 Resetting the system settings
The following system settings can be reset to the default condition:
The system settings are reset in the menu, Storage & config / System / Reset.
To open the Storage & config menu, press the <MENU/ENTER__> key in the
measured value display.
Setting Default settings
Language English
Audio signal on
Baud rate 4800 Baud
Output format ASCII
Decimal separator .
Contrast 50
Illumination Auto
Shutoff time 1 h
Temperature unit °C
Stability control on