YSI MultiLab 4010P-1 - Manual (Page 76)

Data storage MultiLab 4010-1
76 ba76141e03 03/2014
10.3 Measured value data storage
10.3.1 Editing the measured value data storage
The contents of the manual or automatic measurement data storage can be
shown on the display.
Each of the measurement data storages has a function to erase the entire
contents.
Editing the data
storage
The data storage is edited in the menu, Storage & config / Data storage. To
open the Storage & config menu, press the <MENU/ENTER__> key in the
measured value display.
Open the manual or automatic data storage directly with the <RCL> or
<RCL__> key.
Settings
The settings are explained here using the manual data storage as
an example. The same settings and functions are available for the
automatic data storage.
Menu item Setting/
function Description
Data storage /
Manual data storage /
Display - Displays all measurement datasets
page by page.
Further options:

Scroll through the datasets with
<><>.
 Output the displayed dataset to
the interface with <F2>/[USB
output].
 Quit the display with <F1>/
[Back].
Data storage /
Manual data storage /
Output to RS232/USB - Outputs all stored measurement
data to the interface.
Data storage /
Manual data storage /
Erase - Erases the entire manual measure-
ment data storage.
Note:
All calibration data remain stored
when this action is performed.