Xylem inoLab 7310_7310P WASTEWATER pH METER - Manual (Page 65)

pH 7310 Firmware update
ba75929e03 12/2011 65
14 Firmware update
Available firmware updates are provided on the Internet.
With the firmware update program and a PC you can update the firmware of the
pH 7310 to the newest version.
For the update you have to connect the meter to a PC.
For the update via the USB interface, the following is required:

a free USB interface (virtual COM port) on the PC
 the driver for the USB interface (on the enclosed CD-ROM)
 the USB cable (included in the scope of delivery of the pH 7310).
After switching the meter off and on you can check whether the meter has taken
over the new software version (see Y
OU WANT TO KNOW WHICH SOFTWARE
VERSION IS IN THE METER , PAGE 61).
1. Install the downloaded firmware update on a PC.
An update folder is created in the Windows start menu.
If an update folder already exists for the meter (or meter type), the new
data is displayed there.
2. In the windows start menu, open the update folder and start the firmware
update program.
3. Using the USB interface cable, connect the pH 7310 to a USB interface
(virtual COM port) of the PC.
4. Switch on the pH 7310.
5. In the firmware update program, start the update process with OK.
6. Follow the instructions of the firmware update program.
During the programming process, a corresponding message and a
progress bar (in %) are displayed.
The programming process takes approx. three minutes. A terminatory
message is displayed after a successful programming process. The
firmware update is completed.
7. Disconnect the pH 7310 from the PC.
The pH 7310 is ready for operation again.