Xylem MULTI 1970I PORTABLE MULTIPARAMETER METERS - Manual (Page 50)

Operation Multi 1970i
48
4.7.3 Outputting the data storage
You can output the contents of the data storage:
z Stored data on the display
z Calibration data on the display
z Stored data on the serial interface
z Calibration protocol on the interface
Outputting stored data
on the display
You can perform the following activities:
1 Press the <RCL> key repeatedly until StO dISP appears on the
display.
2 Press the <RUN/ENTER> key.
A measured value appears on the display.
The storage location of the data record is displayed for approx.
2 s, then the respective temperature appears.
Display further data of the data record
(ID number, date, time, storage location) Press <RUN/ENTER>
Toggle between two saved measured vari-
ables Press <RUN/EN-
TER> + <M>
Advance one data record (storage location) Press <
▲>
Go back one data record (storage location) Press <
▼>
Store Auto
Ident
I
pH
No.
Time
Cal
O
AR
cm 1/
Tref25
TP
ARng nLF
°
C
cm S/
Sal
%
S
%
m
mg/ l
Oxi
Year
Day.Month
Tref20
LoBat Lin
Sal
TEC
Baud
K /
REL2
pH / mV
REL1
o S T
S I D
RCL
P
Sal
S pH
AR
1
LoBat nLF Lin Oxi
Tref25 Tref20
Cal TEC
Auto Store
8
Time
Year Ident
No. Day.Month
Baud Sal cm 1/
K / %
REL2
pH / mV
m cm S/
%
6
2 5 0
0 3
°
C
TP
REL1
O mg/ l
RCL ARng