Xylem MULTI 1970I PORTABLE MULTIPARAMETER METERS - Manual (Page 64)

Operation Multi 1970i
62
4.10 Reset
You can reset (initialize) the measurement parameters and the config-
uration parameters separately from one another.
Measurement
parameters
The following measurement parameters (pH/O
2
/ InI) can be reset to
the delivery status:
pH
O
2
Note
The calibration data gets lost when the measuring parameters are re-
set. Recalibrate after performing a reset.
Configuration
parameters
The following configuration parameters (InI) are reset to the delivery
status:
Measuring mode pH
Asymmetry 0 mV
Slope -59.16 mV
Measuring mode D. O. concentration
Relative slope 1.00
Salinity (value) 0.0
Salinity (function) Off
Measuring mode
Cell constant 0.475 cm
-1
(fixed)
Baud rate 4800
Display during the
pH calibration Buffer nominal value
Interval 1
(automatically saved)
OFF
Interval 2
(for data transmission)
OFF