Extron Electronics MPX Plus 866 A Rev. B - Manual (Page 100)

SIS ™ Programming and Control, cont’d
MPX Plus 866 A Media Presentation Matrix Switcher • SIS Programming and Control 4-16
PRELIMINAR
Y
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
View ties, gain, volume, mutes, presets, file status, DSVP, and input status (continued)
N The response to the View file directory command differs, depending on whether the command is sent via an RS-232 or
Telnet connection or sent via a Web browser connection.
View file directory
RS-232 and Telnet E
DF
}
filename1 ,date/time,length
]
filename2 ,date/time,length ]
filename3 ,date/time,length
]
• •
• •
filename n,date/time,length ]
List user-supplied files.
space_remaining Bytes•Left
]]
View file directory
Web browser E DF } Var file = new array (); List user-supplied files.
File [1] = ‘filename1,date1,filesize1’,
File [2] = ‘filename2,date3,filesize2’,
File [3] = ‘filename3,date3,filesize3’,
• •
• •
File [n] = ‘filenamen,daten,filesizen’,
File [n+1] = space_remaining Bytes•Left
]]
Erase user-supplied Web
pages/files E
filename EF
}
Delfilename
]
List individual sync
frequency
(Computer video input group,
inputs 1 through 8 only
)
X#
LS
X1#,X1#] Listed as horizontal frequency,
vertical frequency.
Example: 2LS 031.50 , 060.00
] Input 2 horizontal frequency
is 31.5 kHz and its vertical
frequency is 60 Hz.
N The matrix switcher returns 000.00,000.00 if there is no connection or sync frequencies are not applicable.
List input signal status for
all video inputs 0LS X1$
1
X1$
2
X1$
3 ...
X1$
14
]
Each
X1$
value is an input.
RGB delay (ties to outputs in the computer video group only)
Set RGB delay EX@ * X1% D } Out X@• Dly X1%]
Example: E
4*7D
}
Out04
•
Dly07
] Set the RGB interval for ties
to output 4 to 3.5 seconds
(7 x 0.5).
Read RGB delay EX@
D
} X1%]
Example: E
5D
}
05
] Output 5 switching interval
is 2.5 seconds (5 x 0.5).
Command/response table for basic SIS commands (continued)
N
X@
= Output number 01 – 12 for video
01 – 06 for audio
X#
= Input number 01 – 14
X1#
= Sync frequency xxx .xx (frequency in Hz (V) or kHz (H))
X1$
= Signal detection 0 = no input detected, 1 = input detected
X1%
= RGB delay interval Delay in ½ second increments (10 maximum)