Extron Electronics MPX Plus 866 A Rev. B - Manual (Page 133)

5-27 MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software
PRELIMINAR
Y
Recent Files — Opens a list of recently opened or saved DSP configuration files,
making it easy to select one to open.
Exit — Closes the DSP Configurator Program.
DSP Configurator Edit menu
Cut — Copies all of the parameters of a selected processor block
or set of selected blocks to the clipboard and removes the
block(s) from the processor stream.
N Gain blocks are always present and cannot be Cut.
N Processor blocks are removed from the processor stream after a Cut and a
subsequent Paste operation.
N Processor blocks and their parameters can be pasted only into another block of
the same type. For example, the input 1 filter block and all of its parameters can
be copied to the input 2 filter block but not to the input 1 delay block.
Copy — Copies all of the parameters of a selected processor block, gain block, or set
of selected blocks to the clipboard.
Paste — Inserts processor blocks and their parameters from the clipboard into the
DSP Configurator program at the location selected.
DSP Configurator View menu
Audio & Video I/O — Selects the audio and video I/O page
for the DSP Configurator program (the default view).
Audio I/O — Selects the audio-only I/O page for the DSP
Configurator program.
Video I/O — Selects the video-only I/O page for the DSP
Configurator program.
Meter Bridge — Opens a Meters dialog box (figure 5-19)
that gives you a “system at a glance” view of the audio level at each input and
output.
N Meter Bridge is available in Live mode only and only while connected via the
switcher’s LAN port.
Figure 5-19 — Meter dialog box
Re-enable all dialogs — Re-enables all dialog boxes, the pop-up windows that
allow you to make changes to a block’s parameters.
Error log — A troubleshooting tool, error log lists error messages.
Group Controls — Opens the the Group Controls dialog box. See “Viewing and
using a group master“ on page 5-18.