Preliminar y, Switcher software, cont’d – Extron Electronics MPX Plus 866 A Rev. B User Manual
Page 130
Switcher Software, cont’d
MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software
5-24
PRELIMINAR
Y
3
.
If you selected TCP/IP in step 2
:
a
. Observe the IP Address field in the IP Connection window. The field
displays the last IP address entered.
If the IP Address field is correct
, proceed to step 3b.
If the address is not correct,
either click in the IP Address field and
enter the IP address or click on the scroll down button ( ) to open a
drop-down list and select from among the recently used addresses.
Proceed to step 3b.
N
If the local system administrators have not changed the value, the factory-
specified default, 192.168.254.254, is the correct value for this field.
b
. If the switcher is password protected, click in the Password field and
enter the appropriate administrator password.
c
. Click Ok.
The Synchronize with Device dialog box (figure 5-18, on page 5-25) appears.
Proceed to step 5.
4
.
If you selected RS-232 in step 2
:
a
. Click the Com Port drop-down menu and select the PC’s comm port
that is connected to the switcher’s front panel Configuration port or rear
panel RS-232 port.
b
. Check the baud rate displayed in the comm port selection
window. If you need to change the baud rate to match
the switcher’s rate, click the Baud Rate drop-down menu
and select the desired baud rate. The default is 9600.
c
. Click Ok.
The Synchronize with Device dialog box appears. Proceed to step 5.
5
.
If necessary
and as desired, click (figure 5-18) either the:
• Pull radio button (to configure the DSP Configurator program to match
the switcher — proceed to step 7)
• Push radio button (to configure the switcher to match the DSP
Configurator program — proceed to step 6)
N
Extron recommends performing a design rule verification before pushing to