Extron Electronics MPX Plus 866 A Rev. B - Manual (Page 140)

Switcher Software, cont’d
MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software 5-34
PRELIMINAR
Y
DSP Configurator-unique navigation
Making ties
Video and audio ties can be made from the keyboard as follows:
1 . Arrow ( , , , and ) and/or Tab (
Tab
) to the A/V matrix block ( b ) input
node ( ) from which you will make the tie. The node is marked by a green
outline ( ).
2 . Press and hold the Shift
Shift
key while you press the right arrow to drag
the potential tie (dashed line) to the corresponding output node (input 1 to
output 1, 2 to 2, and so on).
N If input number 7 or 8 is selected in step 1, when you perform step 2, the
potential tie is to output 6.
3 . Release the Shift
Shift
key.
4 . Press the Enter
Enter
key to execute the tie.
5 . If desired to make additional ties from the same input , press the
up arrow or down arrow (Shift
Shift
is not required) to select another
output to tie to the same input.
6 . If you made additional ties from the same input , press the Enter
Enter
key to
execute the tie.
7 . If desired , repeat steps 5 and 6 to tie additional outputs to the same input.
8 . If desired to make ties from a different input , press the left arrow key
once, and repeat steps 1 through 7.
9 . Press the Tab
Tab
key, Esc
Esc
key, right arrow key, or left arrow key to
exit the set ties operation.
Highlighting and marking items, cutting or copying, saving a preset
When an item within the program is selected, it is green highlighted. One or more
highlighted items can be cut, copied, pasted, or saved as a preset. The cut, copy,
and paste functions can be performed using the task bar menus (see the Alt
Alt
key,
above) or the shortcuts described on the previous page.
N When an item is cut, it is not removed from its original location until it has been
pasted in its new location.
Highlight multiple elements for cut, copy, paste, or a preset as follows:
1 . Use the arrow ( , , , and ) key(s) to move to the first block to
highlight.
2 . To highlight sequential blocks:
a
. Press and hold the Shift
Shift
key, then use the arrow ( , , , and )
key(s) to navigate to and highlight additional elements.
When you reach the last element you want highlighted, release the
Shift
Shift
key.
3 . To highlight non-sequential blocks :
a . Press and hold the Ctrl
Ctrl
key, then use the arrow ( , , , and )
key(s) to navigate to the next desired element
b . Release the Ctrl
Ctrl
key.
c . To highlight sequential blocks, press and hold the Shift
Shift
key,
then use the arrow ( , , , and ) key to navigate to and highlight
additional elements.