Extron Electronics MPX Plus 866 A Rev. B - Manual (Page 159)

5-53 MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software
PRELIMINAR
Y
WCP Windows buttons, drop boxes, and trash
The buttons, drop boxes, and trash can on the right side of the
program window perform the following functions:
Power —
Unavailable for MPX Plus 866 A switcher, because the
switcher power cannot be controlled via software.
Executive Mode — Allows you to lock out front panel operations,
except for the view-only mode functions. Click the button to
cycle between Lock mode 0 (the indicator is white), Lock mode 1
(the indicator displays red), and Lock mode 2 (orange).
N See “Setting the front panel locks ( Executive modes)” in
chapter 3, “Operation” for more information on the Lock modes.
Presets menu — Displays a list of up to 32 presets. You can select a
preset from the list to display it in the window and either activate
it (Go) or delete it (Delete).
Go — Activates the selected preset as the current configuration.
Save as — Allows the current set of ties to be saved as a preset. Enter
the preset number when prompted to do so.
Delete — Allows the current preset to be deleted.
Changes – Take — Allows you to save to file any changes made to
the displayed configuration.
Changes – Cancel — Returns to the previous screen, undoing any changes you
have made.
Trash can — Drag and drop from an input or output button to the trash can to clear
all ties associated with that input or output.
WCP Windows menus
WCP File menu
Save matrix settings as ... — Saves a complete set of
up to 32 presets, plus the last active setting (preset #0),
to a file. Saved settings include audio gain settings (if
specified), assigned icons, and icon captions.
Restore matrix settings from ... — Loads and activates a
previously saved setting file.
Save this-session’s settings — Saves the current assigned
icons and icon captions.
Restore last-session’s settings — Loads the icons and icon captions that were
saved during the last session. If you saved the previous session’s changes to disk
the last time you exited the program, the ties from that session are also loaded.
Select printer ... — Selects the target printer from a list of connected printers.
Print tie map — Prints the tie set that is displayed on the screen.
Exit — Closes the Matrix Switchers Control Program.