eLine Technology PRO3 User Manual - Manual (Page 33)

33
Ｎｅｔ ＤＶＲ
Chapter 4 Device Operation
4.1.2 System Login
Power on: After connected up the power cable, the front panel of the DVR will start and enter the standby state. Click the “Power” button on the remote controller for 3 seconds
to enter the running state.
Power off: When the system is under the running state, click “Power” button on the remote controller to popup the shut down interface. And clicked the “Confirm” button, the system
will enter the standby state.
Login/Lock: To avoid unauthorized user using the machine or influencing the system’ s normal working, we specially set the key lock and unlock function for the machine.
4.1.1 Keystroke Unlock/Lock
When multi DVRs are put to work together, using the remote controller may influence the machines which users do not intend to control. So we set system key lock function
correspond to remote control. Under the system management of DVR main menu, please enter series configuration and setup device number, then enable key lock and save it. Now to
press the DN button on the remote controller, the DVR is locked, and you will see the “LOCK” light on the front panel is on. To unlock the DVR, please press the DN button and input
the corresponding DVR device number (Device number range is 0-99, default set is 1).
Note: If the remote control does not respond, please check if this function is enabled.
4.1 Power On/off and Login /Lock
When the system is in the status of locking “ ”, press the “Login/Lock” on the remote controller or right click the mouse, the figure of login will appear as follows right:
Input user name and password on the login port (distribute in authority in advance), after you input correct user name and password and press “ENTER”, the sign “ ” on the lower
left corner will switch to “ ” automatically, and show the current user name. Then you can carry on the operations in the authority to the system at the moment.
1. Default user: admin; default password: 888888.
2. When you input the incorrect password 3 times continuously, the system will alarm and get into the status of locking automatically. In that case, you need to click the “clear”
on the front panel or remote controller to retype the password.
eLineTechnology.com