eLine Technology PRO3 User Manual - Manual (Page 62)

62
Ｕｓｅｒ Ｍａｎｕａｌ
You can check the general information of HDD in HDD management, the interface is as follows:
1) Check the HDD general information: The first row display the disk number corresponding to disk interface; The second row display the HDD device; The 3, 4, 5, 6 rows display
the partition type, status, total capacity, and available capacity. The system only support FAT32 format, please use the HDD which above 32G; If there have multi-partition in one HDD,
the system only read the first partition.
2) Try to use: when disk is abnormal, choose the corresponding disk and click “Try to use”, then the host will forced to use the disk and the host will use the normal partition in it
after rebooting.
3) HDD property: There are Read-Write and Read-only two kinds of attribute, default as Read-Write. If you want to prevent that the important record to be deleted or overwrote and
protect the record, you can set the HDD as Read-Only. Setting steps: Click the “Attribution” button in “Basic information” interface, then open “Disk property setting” interface, set
the “Attribute” value as “Read-Only”, then click “Save” button.
4) HDD Format: Select the right disk number which you want to format, then click the “Format” button.
Notes: When you formating log file, you need select the right HDD which stored the log before click “Format log” button.
4.8.1 Basic Information
eLineTechnology.com