eLine Technology PRO3 User Manual - Manual (Page 51)

51
Ｎｅｔ ＤＶＲ
1. Channel Setting
Enter into “Output” -> “Channel Setting”, the interface is the right figure above. You can set channel name, video mask area, special area, vide adjustment parameter and channel
name position.
(3) Special region
The Special region which you have set will more obvious and clear. You can max set 4 special areas. The setting methos is similar to mask area setting’.
Note: You can only see the special area setting effect in dark case. It will have no difference under normal circumstance.
(2) Video mask setting
In some surveillance occasion, user need to mask the sensitivity or private area in the surveillance area of the location, such as ATM’ s password area.
There has 4 mask methods: Disable, Preview Mask, Record Mask, All Mask. Record Mask and All Mask max support 4 mask areas.
l Disable: Not open Video Mask function.
l Preview Mask: The channel of whole preview realtime-preview image will can not be saw. But it will be recorded.
l Record Mask: It will not show mask area in realtime-preview image, but the set area will not be saw in record image.
l All Mask: The image mask area which you have set will cannot be saw in realtime-preview, record and web access image.
Mask area setting steps:
l Select “Record Mask” or “All Mask” in Video mask drop-down list. Click “Mask Area” button in right side to enter into mask area setting interface.
l Set by mouse: Left click a pane as the start position of the mask area, then click another pane as the end position, and the area will shown.
l Set by remote controller and front panel: press direction key to move the cursor, press “OK” to confirm the start position, then move the cursor to select the area you want to mask,
press “OK” again to confirm the end position. Press “Clear” to cancel the area.
l Back to the channel setting interface, click “Save” to activate the setting.
(1) Channel name
l Channel name can input max 31 characters.
l Left click mouse in the text field, then it will pop out soft-keyboard. The keyboard default as inputting english letters. Can click “Caps” button in soft-keyboard to change case.
l Input by remoter controller: Continuous press numeric key to switch input ways.
l When copy channel settings, it will not copy channel name.
Can click the button right on the text field to switch inputting numbers, English letters, characters.
eLineTechnology.com