eLine Technology PRO3 User Manual - Manual (Page 45)

45
Ｎｅｔ ＤＶＲ
Step3: Define the motion detection sensitivity level: There have 5 levels: 1(lowest level )~5(Highest level). When the system detect that have motion in the scene, it will alarm and
motion record. If you choose low sensitivity, such as 1, it will alarm only when there has big change in the channel scene. If choose 5, if there have little change in the channel scene,
it will motion alarm.
Step4: Detection area setting: Yellow color will detect motion. Grey color will not detect. System default the whole area will detect.
Set motion area by remote controller or by DVR front panel: Press direction key to move the cursor to make sure the start point. Press “OK” button to select, only can select a grid one
by one. Press “Return” button return to motion detection interface to save the setting.
Set motion area by mouse: Left click mouse to select one start point, drag mouse to other place, then loose the mouse, it will display a area box. This area is the motion detection area.
Right click mouse to return pre-interface. Double left click mouse to cancel the motion area setting.
Step5: Set the deployment time (the specific setting please refer to schedule record).
Step6: Linkage setting: Set Trigger Record, Screenshot linkage, Alarm output, Email linkage, PTZ preset point.
l Trigger Record: Select the channel number which you want to set linkage.
l Screenshot linkage: choose the channel which for screenshot linkage and set the motion screenshot at screenshot parameter menu.
l Alarm output: If alarm output setting is blue color means it will alarm when have alarm events. If is grey color mean will not alarm output.
l Email linkage: Select “Email linkage” means DVR system can send the alarm information to your email box which have set when motion alarm happens.
l PTZ preset point: System support the function of dome will turn to preset point when motion happens. (the specific setting please refer to sensor -> PTZ preset point).
eLineTechnology.com