eLine Technology PRO3 User Manual - Manual (Page 55)

55
Ｎｅｔ ＤＶＲ
l Setting and calling preset point by mouse:
software-keyboard, then click “Preset” to activate the setting. Then turn the PTZ to another direction, if you click the “Call” and input the No. (001) which you preset to the box,
the PTZ will turn to the 001 preset point automatically. Right click mouse in blank area to exit the PTZ interface.
l Multi-preset position crusie setting: Click “Cruise setting” in PTZ control interface to enter into setting interface, set related multi-preset point crusie parameter:
(Note: Function only available when DVR in lock status!)
l Cruise cruise track record: Click “Switch” button in PTZ control interface to switch to “Track record” interface (as below picture): Cruise track is pre-record user operation of
dome camera (UP-Down, Speed, Focus, Zoom, Iris), then repeat the same operations all the time.
Operation steps:
Open on track cruise function, first click “Track record” button, operate dome camera some time (such as up, down, speed, focus and so on), then click “End” button to finish
recording track. Click “Running” button, then dome will repeat the track you have set until you operate dome manually.
Note: Currently only PELCOD, PELCOP, SONY, CS850B protocol support track cruise. The protocol which don’t support the function will not display “Track record”, “End”,
and “Running” 3 buttons.
(1) Cruise interval time: 0-99s.
(2) Preset No.: each channel can max set 16 preset position.
(3) Range of preset No.: 001-255, 255 means closed.
Enter the PTZ status, double left click mouse at the preset input text field to enable the software-keyboard and input the preset No. (such as 001). Right click mouse to quit
eLineTechnology.com