Hach-Lange ORBISPHERE 6110 Basic User Manual - Manual (Page 4)

Specification Details
Digital display TFT VGA (640 x 480) color display touch screen with backlight
Operating system Windows CE 4.2
Languages English, German, Spanish, Chinese, Japanese
Digital connections 1 x USB client, 1 x USB host, 1 x Ethernet
General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer’s website.
Safety information
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
Use of hazard information
D A N G E R
Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
W A R N I N G
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious
injury.
C A U T I O N
Indicates a potentially hazardous situation that may result in minor or moderate injury.
N O T I C E
Indicates a situation which, if not avoided, may cause damage to the instrument. Information that requires special
emphasis.
Disclaimer
C A U T I O N
The manufacturer is not responsible for damages resulting from misapplication or misuse of this product and
rejects the regulation of such damages, including direct, indirect and consequential damages, and in full
accordance with applicable law. The user is solely responsible for the identification of critical applications and
risks and taking appropriate measures to protect processes during a possible equipment malfunction.
Use of antifoam
Antifoam is injected into the sample as part of the measurement process. Once a sample has
completed the measurement process it will therefore contain a small amount of antifoam. After
measurement, ensure the sample is disposed of in a sink (or similar) to avoid any risk of ingestion.
Class 1 laser
A Class 1 laser is installed in this instrument. Class 1 lasers are products where the radiant power of
the laser beam accessible (the accessible emission) is always below the Maximum Permissible
4 English