Hach-Lange ORBISPHERE 6110 Basic User Manual - Manual (Page 5)

Exposure value. Therefore, for Class 1 lasers the output power is below the level at which it is
believed eye damage will occur. Exposure to the beam of a Class 1 laser will not result in eye injury.
Class 1 lasers may therefore be considered safe. However, Class 1 laser products may contain laser
systems of a higher class but there are adequate engineering control measures to ensure that
access to the beam is not reasonably likely. This Class 1 laser product complies with 21 CFR
Chapter 1, subchapter J. It is evaluated and tested in accordance with EN 61010-1, Safety
Requirements for Electrical Equipment for Measurement and Control and Laboratory Use and
IEC/EN 60825-1, Safety of Laser Products.
CFL backlight
The CFL (compact florescent light) used for backlighting the screen display contains a small amount
of mercury. Please dispose of any used CFL’s in accordance with local, state or federal laws
concerning the disposal of products containing mercury.
Precautionary labels
Read all labels and tags attached to the product. Personal injury or damage to the product could
occur if not observed. A symbol on the instrument is referenced in the manual with a precautionary
statement.
This symbol, when noted on a product, indicates a potential hazard which could cause serious
personal injury and/or death. The user should reference this instruction manual for operation and/or
safety information.
This symbol, when noted on a product enclosure or barrier, indicates that a risk of electrical shock
and/or electrocution exists and indicates that only individuals qualified to work with hazardous
voltages should open the enclosure or remove the barrier.
This symbol, when noted on the product, indicates the presence of devices sensitive to electrostatic
discharge and indicates that care must be taken to prevent damage to them.
Electrical equipment marked with this symbol may not be disposed of in European public disposal
systems. In conformity with European local and national regulations, European electrical equipment
users must now return old or end-of-life equipment to the manufacturer for disposal at no charge to
the user.
Note: For return for recycling, please contact the equipment producer or supplier for instructions on how to return
end-of-life equipment, producer-supplied electrical accessories, and all auxiliary items for proper disposal.
Products marked with this symbol indicates that the product contains toxic or hazardous substances
or elements. The number inside the symbol indicates the environmental protection use period in
years.
Installation
W A R N I N G
This section provides necessary information to install and connect the analyzer. The installation of the analyzer
should be performed in accordance with relevant local regulations, and only by personnel trained and
experienced in the installation of the 6110 analyzer. Disconnect the power supply of the analyzer before carrying
out any work inside the analyzer. Any work inside the analyzer should be performed exclusively by personnel
specialized and authorized to work on electrical installations. In addition, and in accordance with safety standards,
it must be possible to disconnect the power supply of the analyzer in its immediate vicinity.
W A R N I N G
Electrical danger and fire hazard. Only use the supplied power cable. Only qualified experts may perform the
tasks detailed in the installation section of this manual, while adhering to all locally valid safety regulations.
C A U T I O N
Proper ESD (electrostatic discharge) protocols must be followed to prevent damage to the product when working
with the electronic boards.
English 5