Hach-Lange DR 3800 User Manual - Manual (Page 147)

147
Appendix C HACH Data Trans
The optional HACH Data Trans software must be installed on the
PC for the subsequent to process for measurement data.
1. Press PC & Printer in the Instrument Setup.
2. Select PC.
3. Press Setup to display the PC Setup screen.
For further installation instructions, refer to the HACH Data
Trans user manual.
4. Select Auto-Send: On to send all measured data automatically
to the PC.
Note: If Auto-Send: Off is selected, the "PC & Printer" key must be
pressed, in order to send data to the PC.
Note: The remote function is only for monitoring the data transfer.