Hach-Lange DR 3800 User Manual - Manual (Page 30)

30
Standard Operations
5.2.6 PC and printer
The DR 3800 series is provided with 2 USB interfaces, which are
located on the back of the instrument (see
Figure 2 on page 13 ).
These interfaces can be used for exporting data and graphics to a
printer, updating data and for data communication to a personal
computer. These interfaces can be used for the connection of a
USB stick, an external USB keyboard or a USB Barcode handset
scanner.
Note: A USB hub may be used to connect several accessories at a time.
A USB memory stick is used to upgrade data, see section 6.8.2 on
page 110 .
Important Note: A screened USB cable must not be longer than
3 m!
1. Press PC & Printer in the Instrument Setup.
A list with information about the connections opens.
5.2.6.1 Printer setup
For reasons of compatibility, the printer language must be
HP PCL 3.
2. Press Printer.
3. Press Setup to display the Printer Setup screen.
Table 3 USB connector
USB Interfaces Description
USB (Type B)
This USB interface is only intended for the connection DR 3800 - PC (with installation of the
HACH Data Trans Software).
USB (Type A) This USB port can be used to connect a printer, a USB memory stick and keyboard.