Hach-Lange DR 3800 User Manual - Manual (Page 15)

15
Installation
3.5.2 Installation of the cuvette/sample cell adapters
1. Open the cell compartment.
2. Select the correct adapter for the cuvette/sample cell type.
3. Insert the adapter so the arrow on top of the adapter points to
the left ( Figure 5 ) and the orientation tab fits the groove in the
compartment opening. The cuvette/sample cell type imprint
should be legible on the adapter (
Figure 4 ).
Note: The arrow on top of the adapter indicates the direction of the light
beam path.
Figure 4 Cuvette/sample cell adapters
1 Adapter A: 10 mm square cell adapter
2 Adapter B: 1 inch Pour-Thru and multi-path adapter
3 Adapter C: 1 inch round cuvette/sample cell adapter