Hach-Lange DR 3800 User Manual - Manual (Page 26)

26
Standard Operations
7. The display shows the chosen Operator ID.
8. Press OK. The instrument will return to the Instrument Setup
screen and show the selected operator identifier.
9. The chosen Operator ID is activated.
Note: Press Delete to remove an Operator ID from the list.
Note: Alternatively, enter or change an Operator ID in measurement mode.
In the results screen, press Options>More>Instrument Setup or if an
Operator ID is already assigned, select the "Operator ID symbol
immediately in the results screen.
5.2.2 Sample ID
Use this option to enter up to 100 Sample Identification tags (up to
13 characters each) into the instrument. Sample IDs can be used to
specify the sample location or other sample specific information.
1. Press Sample ID in the Instrument Setup.
2. Press New to enter a new Sample ID.
3. Use the alphanumeric keypad to enter a new Sample ID.
Note: If a USB Barcode handset scanner ( see Section 9 on page 131 )
is connected, Sample IDs can also be scanned.
4. Press OK to confirm.