Laurel Electronics LAUREATE SERIES DPM - Manual (Page 17)

-15-
DIGIT SELECT KEY VALUE SELECT KEY
Select 0 through 9 for flash-
ing digit. Decimal location is
fixed by dEC.Pt selection.
Select 0 through 9 for
flashing digit.
0 Relay 1 on,
Relay 2 on
1 Relay 1 off
Relay 2 on
2 Relay 1 on,
Relay 2 off
3 Relay 1 off,
Relay 2 off
0 Alarm 1 nonlatching,
Alarm 2 nonlatching
1 Alarm 1 latching,
Alarm 2 nonlatching
2 Alarm 1 nonlatching,
Alarm 2 latching
3 Alarm 1 latching,
Alarm 2 latching
0 AL1 active high
AL2 active high
1 AL1 active low
AL2 active high
2 AL1 disabled
AL2 active high
3 AL1 active high
AL2 active low
4 AL1 active low
AL2 active low
5 AL1 disabled
AL2 active low
6 AL1 active high
AL2 disabled
7 AL1 active low
AL2 disabled
8 AL1 disabled
AL2 disabled
Hi rd
High Displayed Reading at
High Signal Input
rd0 In
(custom curve only)
Corrects for zero errors
ALSEt
Alarm Operation Setup
(Only enabled if relay output
is installed).
0.0000 0.0000 0.0000
0.0000 0.0000
04.000
Value set to actual voltage or
current input at zero
00000
Relay state when alarm is
active
00000
Alarm latching or nonlatching
00000
Alarm status
MENU KEY