Laurel Electronics LAUREATE SERIES DPM - Manual (Page 27)

-25-
Press the key to display
InPut (Input type selection).
Note: Selection of input type
& range must match jumper
selection in Section 13.1.
Press
to select thermo-
couple type J, K, T, E, R, S
and °C or °F scale (J°F, J°C,
K°F, K°C, t°F, t°C, E°F, E°C,
r°F, r°C, S°F, S°C)
DIGIT SELECT KEY VALUE SELECT KEY
Press the key to display
OFFSt (Zero offset).
Press to display input
selected. Press again
until tC (thermocouple) is
displayed.
Press to display value
and select left digit. Press
again to select another
digit.
Use to set digit values and
set to 000.00 for °F and °C or
set value to 273.2 if °C is
selected to display in °Kelvin
and 459.7 if °F is selected to
display in ° Rankine.
Press the key. Continue to press (or and
simultaneously) until rESEt
is displayed. The meter will now go to the operating mode and display the value of the input
signal.
Press the key to display
SEtuP. (Basic setup)
See Section 9, Page 10 for
detailed description of selec-
tions for digits 1 through 5.
Press
to select value for
flashing digit.
Digit 1:
"0"= 0.1 degree resolution
"3"=1 degree resolution
1 2 3 4 5
Press to display status
and select left digit. Press
again to select another
digit. Selected digit will flash.
MENU KEY