Laurel Electronics LAUREATE SERIES DPM - Manual (Page 26)

-24-
DIGIT SELECT KEY VALUE SELECT KEY
Press the key to display
Hi rd (Desired meter reading
at high signal input).
Press
to display value
and select left digit. Press
again to select another digit.
Decimal point set by Dec.Pt.
Use
to set digit values
and set to 000.00 .
Press the key. Continue to press (or and simultaneously) until rESEt
is displayed. The meter will now go to the operating mode and display the value of the input
signal.
13. THERMOCOUPLES
13.1 RANGE JUMPER SELECTIONS
13.2 MENU SELECTION
Thermocouple type and Celsius or Fahrenheit scale are selected by input type. However,
Kelvin or Rankine may be displayed by entering the appropriate offset to the selected scale.
Although 0.01 degree resolution may be selected, it is not recommended for use with
thermocouples. When setting up the meter, it may be necessary to enable some of the menu
items. See Section 9 for further information.
MENU KEY
Open Thermocouple
Open TC
Indication
Jumpers Required
Upscale c
Downscale d
Thermocouple Type
Type Jumpers Required
J, K, E, N e
T, R, S f
Figure 13.1 Temperature Signal Conditioner
e
f
d
c