Laurel Electronics LAUREATE SERIES DPM - Manual (Page 8)

-6-
5.3 REASSEMBLING THE METER
Reverse the preceding procedures to reinstall the meter in the case. After the meter
is in the case, insert the bottom tabs on the rear panel into the case first. Care must
be taken to ensure the printed circuit boards are properly aligned by the board
retaining pins on the inside of the rear panel.
Figure 5.2
5. MECHANICAL ASSEMBLY
5.1 REMOVING THE REAR PANEL
To remove the rear panel, first remove any connectors that are installed. Press down on both
rear panel retaining tab releases(see Fig. 5.1) and pull the top of the rear panel away from the
case. The bottom of the rear panel will now lift out.
5.2 Removing the meter from the case
After removing the rear panel, the meter can be taken out of the case by carefully grasping the
power supply board and signal conditioner board at the connectors and sliding the unit out the
back of the case. See Figure 5.2.
Figure 5.1
Retaining Tab
and Release
Retaining Tab Retaining Tab
Retaining Tab
and Release