Nova-Tech PMB Moisture Analyzer - Manual (Page 12)

10
| P a g e © Adam Equipment Company 2009
• Protect the Moisture Analyzer from external liquids. Clean any spills
immediately.
• If there are any visible damage to the Moisture Analyzer or the power
cable, Stop using the instrument immediately. Unplug the power and
isolate the analyzer. Do not use until the faults have been repaired.
• All repairs must be done by a trained technician. There are no user
serviceable parts in the enclosure.
• Contact Adam Equipment or your dealer for assistance.
HOT SURFACES
• During test the cover of the heating chamber can become very hot,
especially near the top vent. Keep all material away from the vent area.
Do not touch hot surfaces.
• leave 20 cm (about 8 inches) around the moisture analyzer and 1 m (3 ft.)
above.
• Samples will be hot after a test. Do not use bare fingers to pick up any
samples pans or touch the materials. The internal surfaces of the
weighing chamber may be hot for some time after a test.
MATERIALS
• The PMB moisture analyzer is not suitable for all materials. During the
drying process samples will be heated to high temperatures. Materials that
are flammable or explosive should not be tested.