Nova-Tech PMB Moisture Analyzer - Manual (Page 23)

21
| P a g e © Adam Equipment Company 2009
Press the [Test] key to set the test procedure. During the process use the
numeric entry procedure described in section 4.1 to enter or change a setting.
Pressing [Print] at any time during this procedure will print a list of the current
settings. See 6.1.2
Pressing [Tare] will always escape back to normal weighing without a change
to the parameter being displayed. Any parameter changed before this time
will be accepted.
PROCEDURE
Press [Test] to show “rESULt” with the current setting displayed,
Options are “Moisture”, “Solid”, “ATRO Moist”, “ATRO Solid”
Use arrow keys, [Dspl] and [Test], to change and press [Setup/Enter] to
continue.
Heating Control, show “HEAt”
Options are: “Single”, “Ramp”, “Step”
The next settings will depend upon which heating option was selected:
“Single” Selected
Show “Single” “123 C” with the left digit flashing. The user can use the
[Menu] key (right arrow) to select another digit or the up and down arrows to
set the temperature, Range is 050 C to 160 C
ATRO MOIST
result
MOISTURE
result
SINGLE
Keat