Nova-Tech PMB Moisture Analyzer - Manual (Page 18)

16
| P a g e © Adam Equipment Company 2009
5.0 REAR PANEL INTERFACES
The rear panel has connectors for the data interface, fuse holder, security
lock location and power supply input.
5.1 POWER
Make certain your analyzer is compatible with the mains power supply in your
area. If the voltage is not the same the analyzer can be damaged. Contact
your supplier if you require assistance.
The fuse should only be replaced with a time lag type fuse of the correct
current rating. The fuse is a standard 5 x 20mm size. To replace the fuse
remove all power from the analyzer, unscrew the fuse holder cover to extract
the old fuse, replace with a new fuse. If the fuse should blow again, the
analyzer must be serviced by a qualified service representative. There are no
user serviceable parts inside. Contact your supplier.
5.2 DATA INTERFACES
The analyzer has data interfaces for a variety of applications.
The RS232 interface is a general purpose serial interface for communications
with the analyzer, using a DE-9P type connector. Refer to section 11.0 for
details of the interface.
The USB I/O interface is similar to the RS-232 in that it is also a serial
interface. The functions of the RS-232 and USB I/O are similar. See section
11.0 for more details on using the USB I/O.