E-Mon E-MM-RTU-D-N - Manual (Page 32)

Chapter 3 Multi-Mon Display Operations Menu Operations
32 Multi-Mon Multiple Circuit Energy Monitor
Label Label Label Label Parameter Parameter Parameter Parameter Options Options Options Options Default Default Default Default Description Description Description Description
Ratio V1 Ratio V1 Ratio V1 Ratio V1----V3 V3 V3 V3 V1-V3 voltage
transformer
ratio correction
factor 0.700 to 1.300 1.000 The ratio of the true
transformer ratio to the
marked ratio.
Angle V1 Angle V1 Angle V1 Angle V1----V3 V3 V3 V3 V1-V3
transformer
phase angle
error, minutes -600 to 600
0 The phase
displacement, in
minutes, between the
primary and secondary
values. The phase
angle of a voltage
transformer is positive
when the secondary
value leads the primary
value.
Ratio I1 Ratio I1 Ratio I1 Ratio I1----IIII36 36 36 36 I1-I36 current
transformer
ratio correction
factor 0.700 to 1.300 1.000 The ratio of the true
transformer ratio to the
marked ratio.
Angle I1 Angle I1 Angle I1 Angle I1----I36 I36 I36 I36 I1-I36
transformer
phase angle
error, minutes -600 to 600
0 The phase
displacement, in
minutes, between the
primary and secondary
values. The phase
angle of a current
transformer is positive
when the secondary
value leads the primary
value.
Device Options Device Options Device Options Device Options
This menu allows you to select some user-configurable device options or put
the Multi-Mon into energy test mode.
To enter the menu, select the Options entry from the main menu, then press
ENTER. For instructions on navigating in the menu, see
Viewing and
Changing Setup Items .
The following table lists available options.
Label Label Label Label Parameter Parameter Parameter Parameter Options Options Options Options Default Default Default Default Description Description Description Description
PowMode PowMode PowMode PowMode Power
calculation
mode Reactive,
NonActive (non-
active power) Reactive The method used for
calculating reactive
and apparent powers
ErgyRoll ErgyRoll ErgyRoll ErgyRoll Energy roll
value 100000.0-
100000000.0
kWh 100000000.0 The value at which
energy counters roll
over to zero
TestMode TestMode TestMode TestMode Energy test
mode OFF, Wh, varh OFF Setting this option
puts the device into
the energy test mode
PlsConst PlsConst PlsConst PlsConst Wh LED pulse
rate,
Wh/pulse 0.01-100.00 5.40Wh/pulse
(one
equivalent
disk
revolution) LED pulse constant -
the amount of
accumulated energy
giving one pulse via
“Wh” LED
WhLEDSrc WhLEDSrc WhLEDSrc WhLEDSrc Energy LED
source
1-40, None 1 Selects a submeter as
a LED pulsing source
Communication Ports Communication Ports Communication Ports Communication Ports
These two menus allow you to configure parameters for communication
ports COM1 and COM2. The Multi-Mon automatically detects a replaceable
communication module and will not allow you to change the baud rate and
data format for the Dial-up modem, and for the Ethernet and RF modules.
Options Exit
Options PowMode
Reactive
ENTER