E-Mon E-MM-RTU-D-N - Manual (Page 45)

Chapter 4 Power Software Configuration tool General Meter Setup
Multi-Mon Multiple Circuit Energy Monitor 45
The following table lists available options.
Label Label Label Label Parameter Parameter Parameter Parameter Options Options Options Options Default Default Default Default Description Description Description Description
SubMeter SubMeter SubMeter SubMeter Submeter number #1–#36 The submeter index
Phase L1 Phase L1 Phase L1 Phase L1
Phase L2
Phase L2 Phase L2 Phase L2
Phase L3
Phase L3 Phase L3 Phase L3
Phase current
input terminal
number I1–I36,
None See
note
1
Links a current input
terminal to the
corresponding submeter’s
phase voltage input V1, V2
or V3
CT CT CT CT Primary, A Primary, A Primary, A Primary, A CT primary
current 2
1-10000 A 50 A Specifies the primary rating
of the submeter current
transformers
1 The device is pre-configured for twelve three-phase submeters as shown
in the picture.
2 Specify the CT ratings assuming a ×200% device inputs overrange. The
device inputs are preset for 100A current transformers with a 50A primary
rating.
Transformer Correction Transformer Correction Transformer Correction Transformer Correction
Transformer correction allows you to compensate ratio and phase angle
inaccuracies of the user voltage transformers and Multi-Mon CTs.
To enter the setup dialog, select the device site from the list box 1 on the
Power Software toolbar, and then select Transformer Correction from the
Meter Setup menu.
If you use standard current transformers listed in the last table column, select
a transformer type to preset the transformer ratio correction factor and phase
angle error to their typical values.
1 - User CT option is not recommended, it doesn’t guaranty proper measurement
- LEM and THI transformer type options are no more manufactured.