E-Mon E-MM-RTU-D-N - Manual (Page 54)

Chapter 4 Power Software Configuration tool Remote Device Control
54 Multi-Mon Multiple Circuit Energy Monitor
Updating the Clock Updating the Clock Updating the Clock Updating the Clock
To update the RTC clock in your device, select a site with base device
address from the list box on the toolbar, check the On-line button on the
toolbar, and then select RTC from the Monitor menu.
The RTC dialog box displays the current PC time and the time in your
device. To synchronize the device clock with the PC clock, click Set.
Clearin
g Maximum Demands and Log Files
Power Software allows you to remotely clear maximum demands and log
files individually in each submeter.
To open the dialog box, select a device site from the list box on the toolbar,
check the On-line button, and then select Reset from the Monitor menu.
To reset the desired registers or to clear a file:
1. Click on the corresponding button, and then confirm your command.
2. If a target has more than one component, you are allowed to select
components to reset.
3. Check the corresponding boxes and click OK.