E-Mon E-MM-RTU-D-N - Manual (Page 53)

Chapter 4 Power Software Configuration tool Remote Device Control
Multi-Mon Multiple Circuit Energy Monitor 53
2. Configure the list of parameters to be recorded in the data log file. See
Parameters for Data Monitoring and Logging in Appendix C for a list of
the available parameters.
3. Add the name for your data log file in the Name box. It will appear in the
data log reports.
4. Save your new setup to the device database, and send it to the meter.
5. Configure a setpoint for periodic triggering the Data recorder using the
MINUTE INTERVAL trigger (see Using Alarm/Control Setpoints ).
Rem Rem Rem Remote Device Control ote Device Control ote Device Control ote Device Control
This section describes some online operations on the Multi-Mon you can
perform through Power Software. To access device control options you
should have your device online.
Viewing and Clearing Device Diagnostics Viewing and Clearing Device Diagnostics Viewing and Clearing Device Diagnostics Viewing and Clearing Device Diagnostics
To view or clear the device diagnostics status, check the On-line button on
the Power Software toolbar and select Device Control from the Monitor
menu.
Refer to Device Diagnostic Codes in Appendix F for the list of diagnostic
codes and their meanings. See Device Diagnostics in Chapter 2 for more
information on the Multi-Mon built-in diagnostics.
Click on the Clear button to clear the device diagnostics. You must be
connected to the Multi-Mon using the device base address to be able to
clear the diagnostics status.