Fairbanks FB2550 SERIES - Manual (Page 135)

Section 7: Video Camera Programming
07/2012 135 51254 Rev. 3
7.2.3. RESETTING TO THE AXIS FACTORY DEFAULTS
Restoring the Factory Default Settings is used when the previous steps do not
resolve problems with the Camera Unit.
1. Disconnect the POWER
CABLE from the Camera
unit.
2. Remove the two (2) Torx
screws, holding the camera
into place with a
T20
ALLEN KEY .
3. Flip the camera over to reveal
the control components on the
bottom.
4. Reconnect the POWER CABLE .
– Wait approximately fifteen (15) seconds until the NET and PWR led lights
are orange.
5. Press and hold the RESET button for approximately thirty (30) seconds
until the NET led light flickers green, then release RESET button.
– Doing this resets the Factory Defaults.
6. Reassemble the Camera Unit and follow STEPS 1-16 from SECTION
11.2. and 11.2.1. to complete the programming process.
TORX Screws
RESET NET PWR
SWITCH LED LED