Method 1 – pre-configured output, continued – Fairbanks FB2550 SERIES User Manual
Page 91
Section 5: Input/ Output
07/2012
91
51254 Rev. 3
5.8.3. METHOD 1 – PRE-CONFIGURED OUTPUT,
CONTINUED
6. Select the
LOAD
button.
– This selection will bring up a menu a
five (5) pre-configured outputs.
7. When configuring an output data
string, the Fairbanks’ FB2550 has
seven (7) commonly used pre-
configured outputs.
8. Select the correct data string type.
Displayed below are the data string protocols.
*
Fairbanks
<STX><A><B><C><GGGGGG><TTTTTT><CR>
Toledo
<STX><A><B><C><GGGGGG><TTTTTT><CR>
Cardinal
<CR><P><WWWWWW><m><SP><U><SP><g><SP><SP><ETX>
Weightronix
< ><M><WWWWWW>< ><U><CR><LF>
Condec
<STX><P><WWWWWW><U><G><M><CR>
DT7000 Anybus
<STX><SW0><SW1><SW2><UD><GW><TW>NW><SP1><SP2><FR><UD><CRC><XCH>
SMA Protocol
<LF> <S> <R> <N> <M> <F> <XXXXXX.XXX> <UUU> <CR>
*
See
Appendix II: Data Output
for further information.