Fairbanks Tundra Series Truck Scale - Manual (Page 34)

Section 4: Scale Installation
12/12 34 51193 Revision 5
4.8. REPLACING THE LOCATOR TOOLS WITH LOAD CELLS
1. Place hydraulic jack under the girder, then lift the platform so the locating tool can
be removed from the upper and lower bearing cups.
2. Grease and install the inner O-ring for the load cell cup at on each base plate.
3. On all cups, grease the large outer O-
rings, then install one into the groove on
the outside of each cup.
4. Install the load cell and carefully lower
the scale
(using the hydraulic jack)
while seating the load cell into the cups.
5. Recheck to be sure each load cell is still
plumb after all load cells are installed.