Fairbanks Tundra Series Truck Scale - Manual (Page 38)

Section 5: Electrical Installation
12/12 38 51193 Revision 5
5.2.2. Tightening O-rings
Take extra care when securing O-ring Seals. The Wire Gland Fittings can be
forced out of position if the bushing itself is not tight.

Do not over-tighten the bushings where they turn.

Do not allow the O-ring to spin out of position when
tightening the wire gland fitting.
Follow these steps to prevent O-ring seal problems.
1. Tighten the inner nut securing the bushing in the hole.
2. Insert cable.
3. Carefully tighten gland with pliers until it is very snug.

The box covers
MUST BE secured tightly for protection
against moisture.