Ransburg Aerobell 168 Atex Approved 13350 - Manual (Page 18)

OPERATING CHARACTERISTICS AND SPECIFICATIONS
* When measured with Ransburg meter 76652
Weight
Atomizer (Post Mount 65mm) 2.7 kg (6 lbs.)
Atomizer (Robot Mount /Valves/65mm) 4.4 kg (9.7 lbs.)
Voltage
Maximum Operating Voltage 90 kV
Maximum Operating Current 80 uA
Turbine
Recommended Turbine Speed 15 to 60 Krpm
Turbine Type Impulse - Rear Exhaust
Speed Readout Pickup Magnetic or Light Source (2 pulse/rev.)
Paint
Flow Rate 50-500 cm 3 /min max. (depending on paint)
Normal Supply Pressure 6 to 8 bar (90 psi to 120 psi)
Maximum Pressure 10 bar (150 psi)
Viscosity 20 to 40 Seconds - Ford Cup # 4
Viscosity 20 to 45 Seconds - AFNOR Cup # 4
Paint Resistivity 0.1 MW. to *
Air Pressure
Microvalve Pilot 4.9 bar (Min.) - 10 bar (Max.) (75-150 psi)
Bearing Air 5.5 bar (Min.) - 7 bar (Max.) (80 - 100 psi)
Shaping Air 7 bar Max. (100 psi)
Brake Air 4 bar Min. - 7 bar Max. (60-100 psi)
Change Time
Rotator Atomizer Less than 5 minutes
Bell Less than 5 minutes
Distance
Target 152 - 305mm (6-12 inches)
Compressed Air Quality See Filter Section
Air Consumption
Bearing Air 57 - 85 slpm (2-3 scfm)
Shaping Air 1 75 to 600 NI/min (2.65-21.2 scfm)
Shaping Air 2 75 to 600 NI/min (2.65-21.2 scfm)
Turbine See Charts
∞
Aerobell 168 - Introduction
Ransburg
LN-9247-13 15