Ransburg Aerobell 168 Atex Approved 13350 - Manual (Page 74)

Step 3
Step 2
Step 1
Release the Fluid Coil (as shown)
from the Rear Manifold using the
Adjustable Wrench.
Using A11373-00 Tubing Removal
Tool push downward on the outer
ring of the push-on fitting.
At the same time pull upward
on the plastic tubing.
Remove all such plastic tubing
from the Rear Manifold.
DISASSEMBLY PROCEDURES
(For Robot/Machine Mount Kits)
Remove the Internal Cup Wash Fitting
from the Rear Manifold.
When assembling the Internal Cup
Wash Fitting, tighten with fingers until
an audible “click” is heard.
Note: Be careful not to drop the Cup
Wash Ferrule.
Make sure when assembling the Internal
Cup Wash Fitting that the ferrule taper
end is inserted into the Internal Cup
Wash Fitting.
Aerobell 168 - Maintenance
Ransburg
LN-9247-13 71