Ransburg Aerobell 168 Atex Approved 13350 - Manual (Page 29)

Paint Supply @ Applicator 1/4” O.D. Tube Fitting
Paint Supply @Valve Manifold 5mm I.D. x 8mm O.D. PFA (.197” I.D. x 5/16” O.D.)
Turbine Supply @ Applicator 6mm I.D. x 8mm O.D. Nylon (.236” I.D, x 5/16” O.D.)
Turbine Braking Air Supply @ Applicator 6mm I.D. x 8mm O.D. Nylon (.236” I.D, x 5/16” O.D.)
Bearing Air Supply @ Applicator
6mm I.D. x 8mm O.D. Nylon (.236” I.D, x 5/16” O.D.)
Bearing Air Return @ Applicator 2.7mm I.D. x .4mm O.D. Nylon (.107 “ I.D. x 5/32” O.D.)
Shaping Air 1 @ Applicator 6mm I.D. x 8mm O.D. Nylon (.236” I.D, x 5/16” O.D.)
Sharping Air 2 @ Applicator 6mm I.D. x 8mm O.D. Nylon (.236” I.D, x 5/16” O.D.)
Interior and Bell Cup Exterior Rinsing
Air/Solvent 1/16” I.D. x 3/32” O.D. PFA
Dump @ Valve Manifold 5mm I.D. x 8mm O.D. PFA (.197” I.D. x 5/16” O.D.)
Pilot for all Microvalves 2.7mm I.D. x .4mm I.D. Nylon (.107 “ I.D. x 5/32” O.D.)
Interior and Bell Cup Exterior Rinsing
Air/Solvent Supply @ Valve Manifold 5mm I.D. x 8mm O.D. PFA (.197” I.D. x 5/16” O.D.)
W A R N I N G
!
† Arcing/fire hazard exist if ungrounded
metal connections (air or fluid) are used in
the spray area. Use plastic non-conductive
connections, or ensure metal connections
are at ground potential.
PFA* hoses must never be replaced with
Nylon hoses. Only Polyamide Nylon hoses
can be used for air connections. Polyure-
thane hoses are prohibited.
* PFA = Ultra Pure Polytetrafluoroethylene
Function Hose Characteristic
HOSE SPECIFICATIONS
† Any user supplied air hoses must be rat-
ed at a minimum working pressure of 100
psig (7 bar)
C A U T I O N !
† Any user supplied fluid hoses must be
rated at a minimum working pressure of 150
psig (10 bar)
C A U T I O N !
Aerobell 168 - Installation
Ransburg
LN-9247-13 26