Ransburg Aerobell 168 Atex Approved 13350 - Manual (Page 62)

Step 8
Step 7
Step 6
Note: The Shape Air Ring has a blue
alignment mark . The blue alignment
mark will line up with the yellow dot
located on the Atomizer Body and
the small yellow line located on the
Turbine. All three (3) alignment
marks will have to be in line when
assembling.
Note: Two (2) locating pins are
mounted on the back of the Shape
Air Ring to insure proper alignment.
Insert the Bell Cup/ Combo Wrench
(RPM-419) across the flats located
on the Turbine. Remove the Bell
Cup by hand.
Bell Cup
When reassembling the Bell Cup
hand tighten is sufficient.
Yellow Dot
Yellow Line
Blue Line
DISASSEMBLY PROCEDURES
(30mm Bell Cup and Shape Air Ring)
Aerobell 168 - Maintenance
Ransburg
LN-9247-13 59