Ransburg Aerobell 168 Atex Approved 13350 - Manual (Page 67)

DISASSEMBLY PROCEDURES
(65mm Bell Cup and Shape Air Ring)
Step 8
Step 7
Step 6
The Bell Cup should turn easily
by hand.
When reassembling the Bell Cup
hand tighten is sufficient.
Remove Shape Air Ring. Pull
straight off.
Note: The Shape Air Ring is
sealed with a O-ring and may
be difficult to remove.
Note: When reassembling an
audible “Click” should be heard.
Note: The Shape Air Ring has a
blue alignment mark . The blue
alignment mark will line up with the
yellow dot located on the Atomizer
Body and the small yellow line lo-
cated on the Turbine. All three (3)
alignment marks will have to be in
line when assembling.
Yellow Dot
Yellow Line
Blue Line
Aerobell 168 - Maintenance
Ransburg
LN-9247-13 64