LevelOne GSW-4876 - Manual (Page 117)

C HAPTER 4 | Configuring the Switch
Configuring Security
– 117 –
C ONFIGURING G LOBAL AND P ORT S ETTINGS FOR ARP I NSPECTION
Use the ARP Inspection Configuration page to enable ARP inspection
globally for the switch and for any ports on which it is required.
P ATH
Advanced Configuration, Security, Network, ARP Inspection, Configuration
P ARAMETERS
These parameters are displayed:
Global Configuration
◆ Mode – Enables Dynamic ARP Inspection globally. (Default: Disabled)
◆ Translate dynamic to static – Click to translate all dynamic entries to
static entries.
Port Mode Configuration
◆ Port – Port identifier
◆ Mode – Enables Dynamic ARP Inspection on a given port. Only when
both Global Mode and Port Mode on a given port are enabled, will ARP
Inspection be enabled on a given port. (Default: Disabled)
W EB I NTERFACE
To configure global and port settings for ARP Inspection:
1. Click Advanced Configuration, Security, Network, ARP Inspection,
Configuration.
2. Enable ARP inspection globally, and on any ports where it is required.
3. Click Save.
Figure 39: Configuring Global and Port Settings for ARP Inspection