LevelOne GSW-4876 - Manual (Page 250)

C HAPTER 5 | Monitoring the Switch
Displaying Information on LACP
– 250 –
◆ LACP – Shows LACP status:
■
Yes – LACP is enabled and the port link is up.
■
No – LACP is not enabled or the port link is down.
■
Backup – The port could not join the aggregation group but will
join if other port leaves. Meanwhile it's LACP status is disabled.
◆ Key – Current operational value of the key for the aggregation port.
Note that only ports with the same key can aggregate together.
◆ Aggr ID – The Aggregation ID assigned to this LAG.
◆ Partner System ID – LAG partner's system ID assigned by the LACP
protocol (i.e., its MAC address).
◆ Partner Port – The partner port connected to this local port.
◆ Partner Priority – The partner port priority used to select a backup
link.
W EB I NTERFACE
To display LACP status for local ports this switch, click Monitor, LACP, Port
Status.
Figure 122: LACP Port Status
D ISPLAYING LACP
P ORT S TATISTICS
Use the LACP Port Statistics page to display statistics on LACP control
packets crossing on each port.
P ATH
Monitor, LACP, Port Statistics
P ARAMETERS
These parameters are displayed:
◆ Port – Port Identifier.
◆ LACP Transmitted – The number of LACP frames sent from each port.
◆ LACP Received – The number of LACP frames received at each port.
◆ Discarded – The number of unknown or illegal LACP frames that have
been discarded at each port.