LevelOne GSW-4876 - Manual (Page 284)

C HAPTER 7 | Performing System Maintenance
Restoring Factory Defaults
– 284 –
R ESTORING F ACTORY D EFAULTS
Use the Factory Defaults page to restore the original factory settings. Note
that the LAN IP Address, Subnet Mask and Gateway IP Address will be
reset to their factory defaults.
P ATH
Maintenance, Restart Device
W EB I NTERFACE
To restore factory defaults:
1.
Click Maintenance, Factory Defaults.
2.
Click Yes.
The factory defaults are immediately restored, which means that no reboot
is necessary.
Figure 149: Factory Defaults
U PGRADING F IRMWARE
Use the Software Upload page to upgrade the switch’s system firmware by
specifying a file provided by LevelOne. You can download firmware files for
your switch from the Support section of the LevelOne web site at
http://www.level1.com
P ATH
Maintenance, Software Upload
W EB I NTERFACE
To upgrade firmware:
1.
Click Maintenance, Software Upload.
2.
Click the Browse button, and select the firmware file.
3.
Click the Upload button to upgrade the switch’s firmware.