LevelOne GSW-4876 - Manual (Page 184)

C HAPTER 4 | Configuring the Switch
Quality of Service
– 184 –
C ONFIGURING P ORT
C LASSIFICATION
Use the QoS Ingress Port Classification page to set the basic QoS
parameters for a port, including the default traffic class, DP level (IEEE
802.1p), and DSCP-based QoS classification.
P ATH
Advanced Configuration, QoS, Port Classification
P ARAMETERS
These parameters are displayed:
QoS Ingress Port Classification
◆ Port – Port identifier.
◆ QoS class – Controls the default QoS class, i.e., the QoS class for
frames not classified in any other way. There is a one to one mapping
between QoS class, queue and priority. A QoS class of 0 (zero) has the
lowest priority. (Range: 0-7; Default: 0)
◆ DP level – Controls the default drop priority for frames not classified in
any other way. (Range: 0-1; Default: 0)
◆ DSCP Based – Click to Enable DSCP Based QoS Ingress Port
Classification (see page 193 ).
W EB I NTERFACE
To set the basic QoS parameters for a port:
1.
Click Advanced Configuration, QoS, Port Classification.
2.
Set any of the ingress port QoS classification parameters.
3.
Click Save.
Figure 73: Configuring Ingress Port QoS Classification